In this tutorial, we will describe the necessary steps to configure two-factor authentication (2FA) using Google authenticator on an Ubuntu 16.04 VPS. This application includes implementations of one-time passcode generators for several mobile platforms. This method adds another layer of protection to your server adding an extra step to the basic login procedure.
Login to your server via SSH as user root
ssh [email protected]_Address
apt-get update && apt-get upgrade
Install the Google Authenticator package.
apt-get install libpam-google-authenticator
Once the package is installed, run the google-authenticator program to create a key for the user you will be logging with. The program can generate two types of authentication tokens – time-based and one-time tokens. Time-based passwords will change randomly at a certain amount of time, and one-time passwords are valid for a single authentication.
In our case, we will use time-based passwords. Run the program to create the keys
You will be asked if you want the authentication to be time-based.
Do you want authentication tokens to be time-based (y/n) y
Big QR code will be generated in your terminal. You can scan the code with the authenticator application on your Android/iOS/Windows phone or tablet or enter the secret key generated on the screen.
Emergency scratch codes will also be generated. You can use these codes for authentication in case you lose your mobile device.
Your emergency scratch codes are: 80463533 68335920 89221348 12489672 11144603
Save the authentication settings for the root user by answering YES to the next question
Do you want me to update your "/root/.google_authenticator" file (y/n) y
Next, you can configure the authenticator to generate one-time passwords. Since they last 30 seconds, all generated passwords can be used once.
Do you want to disallow multiple uses of the same authentication token? This restricts you to one login about every 30s, but it increases your chances to notice or even prevent man-in-the-middle attacks (y/n) y
You can use the next setting if you have time syncing issues across your devices, so we will not use this option
By default, tokens are good for 30 seconds and in order to compensate for possible time-skew between the client and the server, we allow an extra token before and after the current time. If you experience problems with poor time synchronization, you can increase the window from its default size of 1:30min to about 4min. Do you want to do so (y/n) n
The next setting prevents brute-force attacks. You will only have three chances per 30 seconds to enter the correct password.
If the computer that you are logging into isn't hardened against brute-force login attempts, you can enable rate-limiting for the authentication module. By default, this limits attackers to no more than 3 login attempts every 30s. Do you want to enable rate-limiting (y/n) y
Now we have the Google Authenticator application configured and the next step is to configure the authentication settings in openSSH. To do so, open the “/etc/pam.d/sshd” file and add the following line to the end of the file:
# vim /etc/pam.d/sshd auth required pam_google_authenticator.so
Save the changes, and open the “/etc/ssh/sshd_config” file and enable Challenge Response Authentication.
# vim /etc/ssh/sshd_config ChallengeResponseAuthentication yes
Save the file, and restart the SSH server for the changes to take effect.
systemctl restart ssh
If you closely followed this tutorial, two-factor authentication is enabled on your server and every time you try to login to your Ubuntu VPS via SSH you will have to enter your user’s password and the verification code generated by Google Authentication application on your mobile device.