Configure Wake on lan in Configuration manager

Client Side Configuration

  • Click on Start menu, Right Click My computer, Click Manager OR Start menu>Run>Type devmgmt.msc
  • Click on Device manager, Expand Network Adapters>Right click on Generic Marvell Yukon chipset based Ethernet controller, Click on property

clip_image006

  • Click on advanced tab, select Wake From Shutdown, on the right hand side, Set value to on

clip_image008

  • Click Wake Up capabilities, on the right hand side set value to Magic packet

clip_image010

  • Click on Power management Tab, check Allow the Computer to turn off this device to save, Allow this device to bring the computer out of standby and only allow management stations to bring the computer out of standby

clip_image012

Server side Configuration

  • Configure System center configuration manager 2007
  • Log on to SCCM server, open ConfigMgr Console, Expand Site management, right click Main site, click on Property

image

  • Click on Wake on LAN Tab, Check Enable Wake on LAN, Check Use Power on commands if the computers support technology, Check Unicast. you can select Subnet directed broadcast if your switch support subnet directed broadcast.

clip_image016

  • Click Port Tab, Select Wake on LAN

clip_image018

  • To use Wake on LAN functionality, always check Enable Wake on LAN in the schedule of deployment of any software.

clip_image020

Leave a Reply